123 issues found

0

Votes
Not Reproducible
I never used to have this problem, but lately, when I try to import my characters from daz3d, CC3 loads a previous character that I had imported, with the clothes, and then overlays the new character clothes on top, and the tongue sticks out of chin.
I cannot seem to figure out the issue....More
  •  1
  •  425
Submitted by jeremylwande

0

Votes
Active
I understand this could be accomplished when using the Goz feature and probably exporting to Obj but this should be built into the Edit pose UI so it doesn't break the workflow..ie stop posing, Goz, send back or export to obj & import as morph etc....More
  •  0
  •  455
Submitted by Ascensi

0

Votes
Released
Open base mesh project.
(At this point export to Zbrush works fine.)
Navigate to the Actor Project Templets then select and apply Head Morph...More
  •  0
  •  617
Submitted by kidmackenzie

0

Votes
Active
It would be very useful to have a transform tool appear at the location of a bodypart once clicked to adjust the size and position -probably a lot quicker than guessing a body part to adjust but the tool should also have an option to switch on/off bodypart highlighting....More
  •  0
  •  537
Submitted by Ascensi

0

Votes
Assigned
In Character Creator 3.22
1. Go into pose mode on any character
2. Activate any of the gizmo-types by either hotkey or through the pose-picker...More
  •  1
  •  490
Submitted by doubblesixx

0

Votes
Active
I have used this feature in Blender and some other software and it makes for a very fast posing having these two combined.
Also having the free gimbal in the center to translate / rotate freely depending on mouse position in relation to the bone is very handy when positioning bones from different...More
  •  0
  •  472
Submitted by doubblesixx

0

Votes
Active
I do a lot of zombie / monster stuff and to get an extra eerie touch to the already withered handpose i often bend fingers slightly backwards to give the pose an extra haunting touch.
Adding the feature to drag the mouse upwards and move fingers up would make it very easy to do all sorts of...More
  •  0
  •  470
Submitted by doubblesixx

0

Votes
Active
I understand you are working on a wrinkle and beard system but I have an idea that I think you might like.
I think it would be nice to brush on your morphs instead of just sliders or push/pull
Add brushes where you can brush on hair add curls or smoothing hair. Brush on rough wrinkles or...More
  •  1
  •  539
Submitted by delebash

0

Votes
Released
1. Launch Character Creator
2. Load Neutral Base
3. Export to FBX (any preset)...More
  •  0
  •  654
Submitted by e.nitievsky

0

Votes
Released
Not sure if this pre-existed in 3.2x or not as I haven't done much in the way of CC3 morphs until recently. However this new problem exists not only with importing avatar obj's exported from CC3 and altered in Zbrush, and imported to create morph sliders. It also happens with avatars exported...More
  •  4
  •  847
Submitted by Colonel_Klink