To modify the mask details, you can use the Brush Tools.
-
Press down the Brush
button in the Brush Tools section.
-
Draw strokes on the image to determine the masked area.
-
Press down the Eraser button and paint on the image to correct the
excessive areas of the mask.
-
Click the Preview button to check out the mask result. The
check-board grids
indicate that the original background is makes.
-
Press down the Blur button and paint on the edges of the mask to smooth the jaggy
ones.
|
|
Jaggy edges
|
Use blur tool to remove the jaggy edges
|
-
Click the OK button if you are satisfied with the mask result.
Note:
|
If you click the Go to Auto Mode , the mask you have created in
the Manual Mode will be discarded.
|
|